Passkey gets a touch-sensitive trigger
Summary
Johannes replaces the previous push button of his Passkey project with a touch surface and plans a final enclosure. The project repository was renamed from passkey to Passkey. The new button works by touch.
Ideas
- The program logic stays the same despite the new input technology.
- A touch sensor improves operation without mechanical wear.
- A 3D-printed enclosure is meant to turn the prototype into a permanent device.
Insights
- Good hardware abstraction allows input components to be swapped without rebuilding the application.
- The step from breadboard to enclosure reveals new questions of security and maintenance.
Facts
- Johannes plans a 3D-printed enclosure.
Recommendations
- Debounce the touch sensor and suppress interference against accidental triggering.
- Protect stored secrets against simple readout of the controller.
References
Read the original article on hanez.org
Links to the original source and the Web Archive open in a new tab.