Upgrade to

         __  __                      _ _
        |  \/  | __ _ _ ____   _____| | |
        | |\/| |/ _` | '__\ \ / / _ \ | |
        | |  | | (_| | |   \ V /  __/ | |
        |_|  |_|\__,_|_|    \_/ \___|_|_|
 _   _     ____              _
| | | |   | __ )  ___   ___ | |_
| | | |___|  _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
 \___/    |____/ \___/ \___/ \__|
 ** MARVELL BOARD: SHEEVA PLUG LE

U-Boot 1.1.4 (Mar 19 2009 - 16:06:59) Marvell version: 3.4.16

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CEE80

Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB
DRAM CS[1] base 0x10000000   size 256MB
DRAM Total size 512MB  16bit width
Flash:  0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0 [PRIME], egiga1
Hit any key to stop autoboot:  0
Marvell>> setenv serverip 172.16.48.20
Marvell>> setenv ipaddr 172.16.48.101
Marvell>> bubt u-boot.bin-3.4.19
Using egiga0 device
TFTP from server 172.16.48.20; our IP address is 172.16.48.101
Filename 'u-boot.bin-3.4.19'.
Load address: 0x2000000
Loading: #################################################################
         ############################
done
Bytes transferred = 474008 (73b98 hex)

**Warning**
If U-Boot Endiannes is going to change (LE->BE or BE->LE), Then Env parameters should be overriden..
Override Env parameters? (y/n) n
Erase 0 - 655360 ...
Copy to Nand Flash...
done
Marvell>> reset